Aqua-Pure CBF150 - Manual (Page 12)

2-6
TO SET TIME OF REGENERATION AND DAYS BETWEEN REGENERATION
Follow these steps for initial set-up of or to make adjustments to the time of regeneration and/or the days
between regenerations. The number of days between regenerations may need to be varied based on usage
and water conditions.
STEP 1
Press “SET” and
▲ for approximately 3 seconds. (This step will not appear if the 7-day clock option is
selected.)
STEP 2
Set Regeneration Time Hour. Set the time for regeneration to start using the
▲ and ▼ arrows. Press SET to
go to the next step.
STEP 3
Set Regeneration Time Minutes using the
▲ and ▼ arrows. Press SET to go to the next step.
STEP 4
Set Number of Days between regeneration cycles using the
▲ and ▼ arrows.
STEP 5
Press SET to complete and return to normal operation.
HOW TO CHANGE THE REGENERATION PROGRAM SETTINGS
STEP 1 - Press and hold SET HOUR and buttons simultaneously until the display begins fl ashing (usually
about three (3) seconds).
STEP 2 - Press and hold SET HOUR and buttons simultaneously until the display begins fl ashing (usually
about three (3) seconds).
STEP 3 - Press the SET HOUR to change the display to P8 or P9.
STEP 4 - Press the SET HOUR button fi ve (5) times to return to the display mode. The time of day should be in
the display.
STEP 1
SET
STEP 2
SET
Regen
Min. Fill
Regen
Time Time
PM
Days To
Regen
STEP 3
SET
Regen
Min. Fill
Regen
Time Time
PM
Days To
Regen
3 seconds
STEP 4
SET
Regen
Min. Fill
Regen
Time Time
PM
Days To
Regen