GE Industrial Solutions MicroVersaTrip Plus and MicroVersaTrip PM DS-206, DSL-206,DS-416, DSL-416, DS-420, DS-632 - Manual (Page 12)

SECTION 4 INSTALLING THE
CONVERSION KIT
(CONTINUED)
Programmer Bracket Installation
Step 1.
Install the programmer bracket to the auxiliary switch plate
of the breaker using the two (2) ¼”-20 x ¾” screws
provided (Fig. 17).
Wire Harness Installation
The wire harness installation consists of the programmer
portion and the communication portion. The
communication harness is supplied, pre-wired for all kits,
but may not be required for MicroVersaTrip
®
Plus trip
units. Separate and route the wire harness as follows:
Step 1.
The 4-pin wire lead plug should be routed through the
notch in the front left-handed corner of the auxiliary switch
mounting plate and along the left side frame of the breaker
to its mating plug on the flux shifter. Tie the harness away
from any moving parts or sharp edges of the breaker
(Fig. 17).
Step 2.
Route the CT wire leads through the original wire channel
along the left side frame of the breaker and along the left-
rear frame of the breaker (Fig. 18). Pay special
attention to polarity.
White - Tap - X2 Black - Common - X1
Step 3.
When the communications portion or the neutral CT
portion of the wire harness is installed, it is recommended
that these leads be tied to the frame of the breaker in such a
manner where it is accessible with the breaker in the
switchgear cubicle. The actual location is dependent on the
configuration of the switchgear assembly and the location
of the mating equipment within the switchgear. The
installation and termination points of these components
may be determined by a field engineer. If either the
communications portion or the neutral CT portion of the
wire harness is utilized, a caution label (Fig. 19 on page
13) should be mounted on the breaker and the compartment
door as a warning to prevent unnecessary damage.
Fig. 17. Installed Programmer Bracket & Wire
Harness
Fig. 18. Wire Harness Routing to CT’s
12