GE Industrial Solutions Evolution Series E9000 - Manual (Page 24)

23
Evolution Series E9000 Installation & Maintenance Guide
Ordering Additional or Replacement Parts
The following information is needed for supplying the
proper equipment:
1.
All data on the motor control center master nameplate
2. If the unit is to be a duplicate of an existing unit, all
data on that unit’s nameplate, located on the right
side of the unit
3. NEMA control center class: I or II
4. NEMA wiring type: A, B or C
5. NEMA enclosure type: 1, 1 Gasketed, 2, 3R or 12
6. Power supply characteristics:
• Voltage
• Number of phases
• Frequency in Hz
7. Control power voltage and frequency in Hz
8. Nameplate designation and title
9. Motor characteristics:
• Horsepower rating
• Speed in RPM
• Temperature rise in °C
• Full-load current in amperes
• Accelerating time in seconds
• Service factor
10. Disconnect characteristics:
• Fusible switch rating (A), fuse type, and clips
• Circuit breaker frame size and current rating (A)
11. NEMA starter size: 1, 2, 3, 4, 5, 6 or 7
12. Starter type: FVNR, FVR, RVNR, 2-speed winding
and accessories:
• Push buttons: start-stop, forward, reverse, up, down
• Transfer switch: H-O-A
• Pilot lights: quantity, color and type
• Interlocks: quantity of NO and NC
• Control power transformer
13. Unit X height or space available
14. Are horizontal shelves or other parts required?
15 Circuitry
16. All other modifications
Other Information
For other information, refer to the nearest GE sales
office and give full details, including equipment name-
plate data. Nameplates are prominently displayed on
the motor control center lineup and contain such
details as service, voltage, frequency, factory order
number. Similar nameplates are mounted on each
motor control center unit.
www.geelectrical.com