GE Industrial Solutions 2 × 12A Digital Dual Output MicroDLynx - Manual (Page 25)

GE
Datasheet
2 × 12A Digital Dual MicroDlynx TM : Non-Isolated DC-DC Power Modules
4.5Vdc –14.4Vdc input; 0.51Vdc to 5.5Vdc output; 2 × 12A Output Current
February 14, 2014 ©2014 General Electric Corporation. All rights reserved. Page 25
Hex
Code
Command Brief Description
Non-Volatile
Memory Storage
38 IOUT_CAL_GAIN
Returns the value of the gain correction term used to correct the measured
output current
Format Linear, two’s complement binary
Bit Position 7 6 5 4 3 2 1 0
Access r r r r r r r r/w
Function Exponent Mantissa
Default Value 1 0 0 0 1 0 0 V
Bit Position 7 6 5 4 3 2 1 0
Access r/w r/w r/w r/w r/w r/w r/w r/w
Function Mantissa
Default Value V: Variable based on factory calibration
YES
39 IOUT_CAL_OFFSET
Returns the value of the offset correction used to correct the measured output
current
Format Linear, two’s complement binary
Bit Position 7 6 5 4 3 2 1 0
Access r r r r r r/w r r
Function Exponent Mantissa
Default Value 1 1 1 0 0 V V V
Bit Position 7 6 5 4 3 2 1 0
Access r r r/w r/w r/w r/w r/w r/w
Function Mantissa
Default Value V: Variable based on factory calibration
YES
46 IOUT_OC_FAULT_LIMIT
Value maybe locked
Sets the output overcurrent fault level in A (cannot be changed)
Format Linear, two’s complement binary
Bit Position 7 6 5 4 3 2 1 0
Access r r r r r r r r
Function Exponent Mantissa
Default Value 1 1 1 1 1 0 0 0
Bit Position 7 6 5 4 3 2 1 0
Access r r/w r/w r/w r/w r/w r/w r/w
Function Mantissa
Default Value 0 0 1 0 1 0 0 0
YES
47 IOUT_OC_FAULT_RESPONSE
Determines module action in response to an IOU_OC_FAULT_LIMIT or a VOUT
undervoltage (UV) fault
Format Unsigned Binary
Bit Position 7 6 5 4 3 2 1 0
Access r r r/w r/w r/w r r r
Function X X RS
[2]
RS
[1]
RS
[0]
x X X
Default Value 0 0 1 1 1 1 0 0
RS[2:0] – Retry Setting
000 Unit does not attempt to restart
111 Unit goes through normal soft start continuously
Any other value is not acceptable
YES
4A IOUT_OC_WARN_LIMIT
Value may be locked
Sets the output overcurrent warning level in A
Format Linear, two’s complement binary
Bit Position 7 6 5 4 3 2 1 0
Access r r r r r r r r
Function Exponent Mantissa
Default Value 1 1 1 1 1 0 0 0
Bit Position 7 6 5 4 3 2 1 0
Access r r/w r/w r/w r/w r/w r/w r/w
Function Mantissa
Default Value 0 0 1 0 0 1 1 0