Asus Pundit-PH3 - Manual (Page 31)

2 - 1 5 2 - 1 5 2 - 1 5 2 - 1 5 2 - 1 5 A S U S P u n d i t - P H 3 A S U S P u n d i t - P H 3 A S U S P u n d i t - P H 3 A S U S P u n d i t - P H 3 A S U S P u n d i t - P H 3
2.7 Installing an optical drive
The system comes with a 5.25-inch drive bay for an optical drive.
2. Drive a screw on the top right
screw hole on both sides of
the drive. The screw holes are
approximately 5 cm from the
drive front panel and 2 cm
from the drive base.
2 2 2 2 2 2 2 2 2 2
3. Lay the system on its side in a
flat and stable surface.
4. Carefully pull the IDE and audio
cables and plugs out from the
bay until the cables are long
enough to connect to the drive.
I D E c a b l e I D E c a b l e I D E c a b l e I D E c a b l e I D E c a b l e
a n d p l u g
a n d p l u g a n d p l u g a n d p l u g a n d p l u g
A u d i o c a b l e A u d i o c a b l e A u d i o c a b l e A u d i o c a b l e A u d i o c a b l e
a n d p l u g
a n d p l u g a n d p l u g a n d p l u g a n d p l u g
5. Connect the IDE cable to the IDE
interface at the back of the
drive. Match the red stripe on
the cable with Pin 1 on the IDE
interface.
6. Connect the optical drive audio
cable to the 4-pin connector at
the back of the optical drive.
To install an optical drive:
1.
Remove the front panel assembly following the instructions in section
“2.3.2 Removing the front panel assembly”.
The IDE and audio plugs are pre-connected to the primary IDE and
internal audio connectors on the motherboard. If you disconnected these
plugs, refer to page 4-5 and 4-7 for their respective locations.
If you plan to install an IDE hard disk drive, set the optical drive as a
slave device before installing it to the system. Refer to the optical drive
documentation for details on how to set the drive as slave device.