Asus Pundit-PH3 - Manual (Page 37)

2 - 2 1 2 - 2 1 2 - 2 1 2 - 2 1 2 - 2 1 A S U S P u n d i t - P H 3 A S U S P u n d i t - P H 3 A S U S P u n d i t - P H 3 A S U S P u n d i t - P H 3 A S U S P u n d i t - P H 3
2.10 Replacing the covers
After you install all the necessary components on the Pundit-PH3 system,
replace the covers following the instructions in this section:
2.10.1 2.10.1 2.10.1 2.10.1 2.10.1 Replacing the front panel assembly Replacing the front panel assembly Replacing the front panel assembly Replacing the front panel assembly Replacing the front panel assembly
If you installed an optical drive, you must remove the optical drive bay
cover before you reinstall the front panel assembly.
To remove the optical drive bay cover:
1. Locate the optical drive bay
cover locks at the back of the
front panel assembly.
The front panel assembly
without the optical drive bay
cover is shown on the right.
2. Press one lock inward (A), then
push the optical drive bay cover
inside the front panel assembly
(B) to release the cover.
A A A A A
B B B B B
To replace the front panel assembly:
1. Hook the hinge-like tabs to the
holes on the right side of the
chassis.
H i n g e - l i k e t a b s H i n g e - l i k e t a b s H i n g e - l i k e t a b s H i n g e - l i k e t a b s H i n g e - l i k e t a b s