Asus G1-P7P55E - Manual (Page 46)

4-5 ASUS G1-P7P55E
3.. ATX.power.connectors.(24-pin.EATXPWR,.4-pin.ATX12V)
These connectors are for ATX power supply plugs. The power supply plugs
are designed to fit these connectors in only one orientation. Find the proper
orientation and push down firmly until the connectors completely fit.
P7P55-M_DP
P7P55-M_DP ATX power connectors
EATXPWR
PIN 1
GND
+5 Volts
+5 Volts
+5 Volts
-5 Volts
GND
GND
GND
PSON#
GND
-12 Volts
+3 Volts
+3 Volts
+12 Volts
+12 Volts
+5V Standby
Power OK
GND
+5 Volts
GND
+5 Volts
GND
+3 Volts
+3 Volts
ATX12V
PIN 1
+12V DC +12V DC
GND GND
• For a fully configured system, we recommend that you use a power supply
unit (PSU) that complies with ATX 12 V Specification 2.0 (or later version)
and provides a minimum power of 400 W.
• Do not forget to connect the 4-pin ATX12V power plug. Otherwise, the
system will not boot.
• We recommend that you use a PSU with a higher power output when
configuring a system with more power-consuming devices or when you
intend to install additional devices. The system may become unstable or
may not boot up if the power is inadequate.
4.. Digital.audio.connector.(4-1.pin.SPDIF_OUT)
This connector is for an additional Sony/Philips Digital Interface (S/PDIF)
port. Connect the S/PDIF Out module cable to this connector, then install the
module to a slot opening at the back of the system chassis.
SPDIF_OUT
+5
V
SPDIFOU
T
GND
P7P55-M_DP
P7P55-M_DP Digital audio connector
The S/PDIF module is purchased separately.