Asus G1-P7P55E - Manual (Page 65)

5-16 Chapter 5: BIOS setup
The Module Version and USB Devices Enabled items show the auto-detected
values. If no USB device is detected, the item shows None.
5.4.5 USB Configuration
The items in this menu allows you to change the USB-related features. Select an
item then press <Enter> to display the configuration options.
USB.Functions.[Enabled]
Allows you to disable or enable the USB functions. Configuration options:
[Disabled] [Enabled]
Legacy.USB.Support.[Auto]
Allows you to enable or disable support for Legacy USB storage devices, including
USB flash drives and USB hard drives. Setting to [Auto] allows the system to
detect the presence of USB devices at startup. If detected, the USB controller
legacy mode is enabled. If no USB device is detected, the legacy USB support is
disabled. Configuration options: [Disabled] [Enabled] [Auto]
BIOS.EHCI.Hand-Off.[Enabled]
Allows you to enable or disable the BIOS EHCI Hand-off function.
Configuration options: [Disabled] [Enabled]
The following items may only appear when a USB storage device is plugged.
USB Mass Storage Device Configuration
USB.Mass.Storage.Reset.Delay.[20.Sec]
Allows you to set the maximum time that the BIOS waits for the USB storage
device to initialize. Configuration options: [10 Sec] [20 Sec] [30 Sec] [40 Sec]
Emulation.Type.[Auto]
Allows you to set the emulation type. Configuration options: [Auto] [Floppy]
[Forced FDD] [Hard Disk] [CDROM]