Armasight IAIR002LP000001 DRAKOS 2 Multi-Spectral Laser Aiming/ Illumination Devices User Manual
Page 20
20
3.1.2 MOUNTING THE LAD ON A PICATINNY/WEAVER
WEAPON RAIL
NOTE:
Remember to zero your weapon prior to installing the LAD or adjust-
ing the boresight.
WARNING:
When installing the equipment on a weapon, be sure the weapon is
CLEAR and that the SAFETY is on before proceeding.
Figure 3-3 shows a single-channel LAD installed on a Picatinny weapon rail.
Install the LAD on a Picatinny/ Weaver rail as follows (refer to Figure 3-4):
1. Unlock the LAD mount’s clamping device by pushing down on the dog
(A) and turning the cam lever (B) towards the arrow (backwards).
2. Install the LAD on the Picatinny/ Weaver rail so that the stop (B, see Figure
3-5) slides into one of the rail’s transverse slots.
3. Affix the LAD to the rail by locking the clamping device.
4. Verify that the clamping device is firmly holding the LAD. If necessary,
adjust the clamping device as detailed in Part 3.1.3: Clamping Device Ad-
justment.
FIGURE 3-3. LAD INSTALLED ON A PICATINNY WEAPON RAIL
A
b
FIGURE 3-4. MOUNT. CAM LEVER