Extron Electronics HAE 100 User Guide - Manual (Page 16)

z z
Video and/or audio cuts in and out.
This is most likely an HDCP issue. If the HDCP output LED is not lit (see "
Front Panel
Features " on page 4), disconnect the HDMI output device to see if the extracted audio
stabilizes. Power cycle the HAE 100 and the connected HDMI devices, paying attention
to the HDCP status LEDs.
If the issue continues, call the Extron S3 Sales and Technical Support Hotline.
z z No image, the image is showing incorrect colors, or other video problems are
visible on the HDMI output.
The source content has been corrupted or there is a compatibility problem. Power cycle
the source, display, and/or HAE 100.
If the issue occurred after changing the Audio Format or EDID Store switch settings (see
"
Rear Panel Features " on page 5), note that it is best to make these adjustments prior
to connecting a source device to the HAE 100.
If the issue continues, call the Extron S3 Sales and Technical Support Hotline.
Specifications
Video
Maximum data rate ........................ 6.75 Gbps (2.25 Gbps per color)
Maximum pixel clock ...................... 225 MHz
Resolution range ............................ Up to 1920x1200 or 1080p @ 60 Hz, 12-bit color
Formats .......................................... RGB and YCbCr digital video
Standards ....................................... DVI 1.0, HDMI 1.3, HDCP 1.2, EDID 1.3
Video input
Number/signal type ........................ 1 single link HDMI
Connectors .................................... 1 female HDMI type A
Equalization ................................... Automatic for up to -12 dB of cable loss
Input cable length .......................... Up to 25' (7.6 m)
NOTE: The transmission distance varies greatly depending on the signal resolution and on the type of cable,
graphics card, and display used in the system.
Video output
Number/signal type ........................ 1 single link HDMI
Connectors .................................... 1 female HDMI type A
Output cable length ....................... Up to 15' (5 m)
Audio
S/N ................................................. >90 dB, balanced, at maximum output
Audio input
Source formats ............................... PCM, Dolby Digital 2/0, Dolby Digital 2/0 Surround, Dolby Digital 5.1,
Dolby Digital EX, DTS Digital Surround 5.1, DTS-ES Matrix 6.1, DTS-ES Discrete 6.1
Audio output — analog
Number/signal type ........................ 1 stereo balanced/unbalanced
Connector ...................................... (1) 3.5 mm captive screw connector, 5 pole
Impedance ..................................... Stereo: 50 ohms unbalanced, 100 ohms balanced
Maximum level (Hi-Z) ...................... >16 dBu, balanced; >7.8 dBV, unbalanced at 1% THD+N
HAE 100 HDMI Audio Extractor • Reference Information 11