Extron Electronics Global Configurator 2.2 - Manual (Page 10)

 Global Configurator, Windows-based Control Programs
PRELIMINAR
Y
Step : Rebuild and upload the configuration.
To complete the upgrade process, you must rebuild the configuration and upload it
to the device. Copies of the configuration files are stored on the MLC/
System 5 IP, so they are not required to reside on your local PC. The configuration
software pulls the configuration from the unit when the application is started.
1. To rebuild and upload the configuration, select Rebuild & Apply
Configuration
from the Tools menu, as shown below.
A message appears, prompting you to proceed with rebuilding the configuration.
2. Click OK.
Step : Apply upgrade to all devices in the project.
Repeat steps 1 through 4 for all MLC 226 IP, MLC 104, MLC 104 IP, and/or
System 5 IP devices in your system.
System  IP Patch Firmware Upgrade
The following instructions allow you to retain IP settings when upgrading from
firmware 1.0x to 2.00 or higher on the System 5 IP Series Switchers . The stored IP
settings include the following:
• IP Address
• Gateway IP Address
• Subnet Mask
• Unit Name
• DHCP Setting
• Port Mapping (telnet/Web/direct access)
For more information please call your Extron Applications Engineer.
PRELIMINAR
Y