Extron Electronics Global Configurator 2.2 - Manual (Page 11)

Upgrade Guide, cont’d
Global Configurator, Windows-based Control Programs 0
PRELIMINAR
Y
The patch (applicable to firmware versions prior to 2.00) loads into a standardized
location on your computer using a Windows installer application. The specific file
name for this patch is 503512V100.s19. The following files are loaded onto your
computer:
• 503512V100.S19
• System_5_IP_FW_Patch_Instruction_01.pdf
• Patch_Web_Loader_Sys5IP.html
• System_5_IP_19_1335_50_V2_00.S19
• System_5_IP_FW_Revision_History_04.pdf
Upgrade instructions using the Patch Web Loader
An easy to use program called the Patch Web Loader can be loaded onto your
System 5 IP switcher to facilitate the upgrade process. After running the software
setup, follow the instructions below to ensure a proper update to the System 5 IP
switcher.
Step : Load the Patch Web Loader.
After you run the software installer, the Patch Web Loader program copies itself
onto your hard drive, but must be uploaded to the switcher.
1. Using Internet Explorer ® , browse to the System 5 IP internal Web page by
entering http://x.x.x.x/nortxe_index.html, where x.x.x.x is the IP address
of the product to update.
2. Select the File Management tab and browse to the directory specified
during setup. The default location is
C:\Program Files\Extron\Firmware\System_5_IP\04 .
3. Select the Patch Web Loader file, Patch_Web_Loader_Sys5IP.html, and
then click Upload File to initiate the process.
PRELIMINAR
Y