Extron Electronics Global Configurator 2.2 - Manual (Page 9)

Upgrade Guide, cont’d
Global Configurator, Windows-based Control Programs 
PRELIMINAR
Y
Upgrading to configuration software ..
After updating the configuration software on your PC to version 3.1.1, you must
rebuild and upload the MLC or System 5 IP configuration. Simply restoring a
previously saved configuration cannot fix inherent problems in version 3.1 of the
configuration software.
Step : Connect with the device.
Open the configuration software and connect to the MLC or System 5 IP device via
RS-232 or IP (shown below).
Step 2: Obtain missing drivers.
If your PC is unable to find certain IR and/or serial drivers in the configuration,
a warning dialog appears (as shown below). If there is no warning, skip to step 3
below.
1. Download missing drivers from the Extron Web site.
2. Place downloaded drivers in the C:\Program Files\Extron\Driver2 directory.
3. Use the driver filters to find the device(s) listed in the dialog above.
When new drivers are successfully downloaded to the PC, you must restart the
configuration software.
PRELIMINAR
Y