Aeromotive 11109 - IN-LINE ELECTRIC FUEL PUMP User Manual
Page 2
The following steps are typical of most installations:
Section 1 - Fuel system installation
Section 2 – Fuel line hose end installation
Section 3 – Electrical Installation
Section 4 – Final checks and system start-up
Fuel Pump Template
Typical hose end to fitting connection:
Typical o-ring sealed port connection:
Hose End
Connect hose end to 37-degree flare side of union.
Do not connect hose end to cutoff side of union!
O-ring sealed AN style port
O-ring
(Install on union fitting between back of
threads and face of hex nut.)
Typically the cutoff side of the union is used as
the o-ring sealed side, leaving the 37-degree
flare side for your hose end connection. In some
cases both sides of the union utilize an o-ring
seal. For example, in this kit a union connects
the both ports of the fuel pump and filter.