Aeromotive 11109 - IN-LINE ELECTRIC FUEL PUMP - Manual (Page 7)

1-34. Using the remaining AN-06 steel braided hose, cut and assemble the steel braided hose and hose ends as shown
in Section 2.
1-35. Thread the straight side of the AN-06 supply line that you have just created onto the above adapter fitting and
tighten. Thread the 90-degree side of the AN-06 supply line on the AN-06 fitting that you installed earlier on the pump
/ filter assembly outlet. Ensure that all lines are routed clear of any suspension, drivetrain, and exhaust components.