Aeromotive 11109 - IN-LINE ELECTRIC FUEL PUMP - Manual (Page 5)

1-17. Using the two supplied 90-degree AN-10 hose ends as a guide, measure the length of AN-10 steel braided line
needed to connect the fuel tank sump outlet to the fuel pump / filter assembly inlet.
1-18. Cut and assemble the steel braided hose and hose ends as shown in Section 2.
1-19. Using the above steel braided hose assembly, connect one end to the outlet of the fuel tank sump and the other
end to the fuel pump / filter assembly inlet and tighten. See figure 1-5.
Note: It is recommended that a fuel shut off valve be installed between the fuel tank outlet and the fuel pump /
filter assembly inlet, these valves are available from most popular racing fitting manufactures; Aeroquip,
Earl’s, Goodridge, Russell, etc.
Figure 1-5
1-20. Using any type of household tape, secure the plastic fuel tank shield to the Aeromotive fuel tank along each of the
fuel tank strap indentations.
1-21. Carefully flip the fuel tank / plastic fuel tank shield assembly over.
1-22. From the old OEM fuel tank, remove the filler neck rubber grommet, fuel level sender, vent and vent grommet, and
wiring harness. Reinstall each of these components in the new Aeromotive fuel tank while inspecting them for any
damage. If any of the OEM components are damaged replacement parts are available through your local Ford dealer
or auto parts store. See figure 1-6.
1-23. Remove the OEM fuel pick up from the OEM fuel tank, inspect the gasket for any damage. Using the OEM gasket
install the Aeromotive provided return pick up block off plate in the new Aeromotive fuel tank.
Figure 1-6