Aeromotive 11109 - IN-LINE ELECTRIC FUEL PUMP User Manual
Page 4
1-9. Install one of the supplied AN-10 o-rings on the cutoff side of the AN-10 cutoff union fitting, if not already installed,
and install on the inlet side of the pump / filter assembly as shown in figure 1-3.
1-10. Install one of the supplied AN-10 o-rings on the AN-10 cutoff side of the AN-10 cutoff to AN-06 reducer union fitting,
if not already installed, and install on the outlet side of the pump / filter assembly as shown in figure 1-3
1-11. Position the fuel pump / filter assembly from above on the opposite end of the plastic fuel tank shield as the sump
cutout. Center the pump / filter assembly in all directions on the flat shown in figure 1-3. Using the fuel pump as a
guide, mark the four pump mounting holes. Insure there are no obstructions behind the plastic fuel tank shield and
drill four ¼” mounting holes.
1-12. The fuel pump should be installed such that when the plastic fuel tank shield is installed the fuel pump outlet is on
the driver side of the vehicle. Secure the fuel pump to the plastic fuel tank shield by installing each of the four ¼”
carriage bolts from the inside of the fuel tank shield, through the fuel tank shield and through the fuel pump mounting
holes. Install each of the four provided flat washers and nuts on the bolts and tighten. The plastic fuel tank shield now
should look similar to the one shown in figure 1-3.
Figure 1-3
1-13. Inspect the inside of the plastic fuel tank shield for any sharp edges that could puncture the fuel tank. If any sharp
edges are found, correct before proceeding.
1-14. Position the plastic fuel tank shield on the Aeromotive fuel tank.
Figure 1-4
1-15. Install one of the supplied AN-10 o-rings on the cutoff side of the AN-10 cutoff union fitting, if not already installed,
and install on the passenger (right) side of the fuel tank sump.
1-16. Install one of the supplied AN-10 o-rings on the AN-10 port plug, if not already installed, and install on the driver
(left) side of the fuel tank sump.
Inlet
Outlet of pump
Cutout for sump
AN-10 Return Line Port
AN-10 Outlet Ports