Aeromotive 11109 - IN-LINE ELECTRIC FUEL PUMP - Manual (Page 8)

Section 2 - Fuel Line Hose End Installation:
CAUTION:
When assembling this product, wear eye goggles and other safety apparel as needed to
protect yourself from debris and sharp edges.
2-1. Wrap hose with masking tape at desired cutoff length. Cut hose through masking tape squarely to desired length
using a cut-off machine or a fine tooth hacksaw. Remove the masking tape.
2-2. Unthread the hose socket from the rest of the hose end fitting.
2-3. Insert hose in the socket with a twisting and pushing motion until the hose is fully seated in the socket.
2-4. Using a grease pencil, marker or tape, mark the location of the hose in relation to the hose socket that you just
installed.
2-5. Using a light oil, lubricate the inside of the hose and hose end mating parts.
2-6. Carefully thread the hose end onto the hose socket, making sure that the hose does not push out of socket, by
observing the mark you placed on the hose in step 2-4.