Alpha Technologies Spectra Series - Manual (Page 29)

Preliminary Operating Instructions 29 of 62 AIP SERVICE NUMBER 1-800-863-3364
If the user is in any menu for longer than 60 seconds without pressing a button, the display mode will
return to the default display mode.
11.2 HOW TO VIEW OR CHANGE INFORMATION
The user can view and change charger settings easily. By using the UP ARROW or DOWN ARROW
buttons, the user can view the different charger information and menus that allow the user to change the
charger profile. In most cases there will be an ‘
→’ to show that a value can be changed after the menu
description. The exception to this is the “Time” menu.
By pressing the DOWN ARROW button you can see the following menus or information:
Fault Codes, DC Settings, Alarm Settings, Eqlz Settings, Hrs Run, InTemp, ExTemp (if
unit has optional Remote Temperature Probe), Time of Day, Pause Time and Next Eqlz
Time. All of these will be explained in SECTION 11.3.
When the display has an ‘
→’ after the menu description, the user can press the RIGHT ARROW button
to get into that menu or toggle between menu choices. The UP and DOWN ARROW buttons allow
values to be changed. After making the changes to the values that are underlined or a cursor is present,
the user must SAVE the change by pressing the RIGHT ARROW button until you get the ‘
→’ again. In
most cases if the user backs out of changing a value by pressing the LEFT ARROW button, the value
will NOT be saved. The value will take affect only when the user presses the RIGHT ARROW button at
the last changeable value.
Example 1 – Changing Float Settings:
Example 1 explains how to change the Float settings for the charger
Press the DOWN ARROW button until you get to the following.
“DC Settings
→”
Press the RIGHT ARROW button and it will show you the charger type. Press the DOWN ARROW
button to get the following.
“Float 2.25V/C
→”
Press the RIGHT ARROW button to get the following.
“Float 2.25V/C”
Notice the arrow is gone and the 2 is underlined or the cursor is under it. The user can change the value
of the digit above the cursor by pressing the up and down arrow buttons. The up button increases to the
next higher digit and the down button decreases. Press the UP ARROW button to get the following.
“Float 2.35V/C”
Pressing the RIGHT ARROW button will move the cursor to the right to get the following.
“Float 2.35V/C”
The cursor has moved and again the value can be changed by pressing the up or down arrow button.
Press the DOWN ARROW button to get the following.
“Float 2.30V/C”
When the cursor is under the farthest right digit, if the user presses the RIGHT ARROW button, the
value shown will be saved and take affect. Press the RIGHT ARROW button to get the following.