Brickcom CB-500A - Manual (Page 35)

- 28 -
Accessing the Network Camera
Check Network Settings
The camera can be connected either before or immediately after the software installation. The
Administrator should complete the network settings on the configuration page, including
entering the correct subnet mask and IP address of gateway and DNS. Ask the network
administrator or Internet service provider for the detail information.
Add Password to Prevent Unauthorized Access
The Administrator should immediately implement a new password as a matter of
prudent security practice. For first time use, the user name and password for the
Administrator are assigned as “admin/admin”. After the Administrator changes the
Administrator password, the web browser will display an authentication window to confirm the
new password. Once the password is set, there is no provision to recover the
Administrator’s password. If the Administrator’s password is lost, the only option is
to restore the original factory default settings.
The Administrator can set up a maximum of ten (10) user accounts. Users will be able to
access the Network Camera, but will not be allowed to access system configurations.
Authentication
To access the camera’s live view, open a web browser and enter the IP address of the camera.
A dialog window will pop requesting a username and password. As stated on the previous
page, for the default username and password for the Administrator are assigned as
“admin/admin”. For accounts other than the administrator’s account, the user can choose
to remember the password for future convenience. It is not recommended to check this box
when viewing the camera feed from a public computer.