Brickcom CB-500A - Manual (Page 64)

- 57 -
4. If Manual mode is selected, the following page will be displayed.
a. Manually enter the Public IP Address, HTTP port and RTSP port or leave the
default values.
Click Apply to apply settings or Cancel to cancel changes.
NOTE - The EasyLink function will not work if the following conditions occur:
1. The camera cannot be located behind a double NAT network.
2. The camera’s IP address cannot be assigned to specific port numbers using the
router’s port forwarding.
3. EasyLink uses UPnP to exchange port information with the router. The camera must
connect to the internet through a router which supports UPnP.