I-View IR-5MIPN42 5-Megapixels IR Bullet IP Camera User Manual
Page 27
27
used camera support Onvif compliant from: http://www.onvif.org. Click “ Onvif setup “ icon to
setup the parameters which you want to run on the Hybrid DVR or NVR.
Compress: Select the suitable codec for video recording and transmission.
Recording resolution: Select the resolution for video recording and display.
Frame rate: Select the frame rate for video recording and display.
Rate Control: You can choice video quality or bit rate from this tab. Good video quality or large
bit rate request bigger storage capability.
IP address: Entry the correct IP address for the connected IP camera. If you do not know the IP
camera’s IP address, you can click “Find” icon to find out the currently connected IP cameras
User name & Password: The user name and password must be matched the setting of IP camera
which you want to connect.
.The default User name / Password is “ admin / 123456 “ and IP address is 192.168.0.123. Some
special issues to cause cannot find out the IP address that you can try the 192.168.123.123
Find: Click this icon to find out all the currently connected IP cameras on the list. You will find
out the network information of each IP camera. Please refer the diagram shown as above Fig A.
Click the IP address and “Select” icon, the IP camera information will be show on.
System Firmware update: Click “System Firmware update icon” icon to update the newest
IP camera firmware; you can check and download the newest firmware version from our
website:
www.i-view.com.tw
.
Change IP: Click “Change IP” icon to setup the DHCP or Static IP address and also modify
the username /Password. Please refer to Fig B diagram. After modification, click “Change”
icon to confirm the setting.
Discover: Click “Discover” icon to research the IP address of system.
Reboot: Click “Reboot” icon to restart this IP camera.
Go Web: Click this icon to enable the I.E. Browser to check/setup the detail parameters.
Select: Choice the IP camera which you find out from the system and then click “Select” icon to
assign this IP camera into the camera channel of Witness NVR.
Advance setup: Click this icon will enable the detail parameters setting of IP camera. You need to
load the Active X if this NVR is activated this process at first time.
The difference IP camera brand has its own “Find” and “Advance setup” setup diagram and