I-View IR-5MIPN42 5-Megapixels IR Bullet IP Camera - Manual (Page 47)

47
I/O & PTZ setup: You can setup the alarm input/output and PTZ protocol from this section.
PTZ: Setup the PTZ parameters such as Baud rate, protocol and ID address. (Option)
Alarm I/O: Alarm input: Setup the name of alarm input and define the level of trigger single.
Alarm output: Setup the name of alarm output; define the mode (NC or NO) and trigger period. (0
ms: Continue trigger)
Alarm Trigger: You can setup the image motion
trigger and sensor alarm trigger from this section.
The detail process show as below: