MoTeC PWC Plug-In ECU - Manual (Page 43)

36 Options to Expand the System MoTeC
Lambda Upgrade is required which allows the use of a single on-board
wideband Lambda controller for NTK UEGO or Bosch LSU sensors.
PWC exhaust systems use a cooling water jacket to surround the exhaust
manifold and some of the exhaust muffler and associated tubing. The exhaust
gases pass through a water canister which can charge the exhaust manifold
with water vapour. This water vapour can drastically shorten the life-span of
Lambda sensors, sometimes to less than one hour.
Important: We do not advise the fitting of Lambda sensors unless you are
prepared to replace them frequently.
For wiring information see the relevant Pin List in the appendices.
Suitable mounting positions for Lambda sensors are shown in the appendix
Lambda Sensor Installation.
Pro Analysis
This upgrade provides access to advanced i2 Pro data analysis software with
multiple graph overlays, X-Y plots, advanced maths functions, synchronised
video (manual alignment), and flexible layouts to accommodate virtually any
user preference. Requires the Data Logging upgrade.
You can try the i2 Pro software by downloading it from the website
www.motec.com.au and use the included demo file.