MoTeC PWC Plug-In ECU - Manual (Page 64)

MoTeC Appendices 57
M400 Pin Sea-Doo Pin Function
Additional Sea-Doo Loom Pins
Unused A02, A03, A04,
A08, A16, A17,
A18, A22, A30,
A32
Unused B03, B04, B05,
B10, B12, B14,
B15, B16, B21,
B25, B36, B37,
B40
Coil 2 A01 Coil2 Drive from IGN4 Module C02
Coil 3 A29 Coil3 Drive from IGN4 Module C03
Coil 1 A41 Coil1 Drive from IGN4 Module C01
Knock
Sensor A09 Optional: Knock Sensor signal to SKM
Knock Module
Water
Speed B06 Water Speed Signal to DMCF K05
(2007)
ECU
Power
Relay B17 Relay Drive - not used as Lanyard
controls ECU power
Lanyard B26 Lanyard Sense - not used as Lanyard
controls ECU power
Dash CAN
Hi B27 STC CAN to Dash @250 kbit/s F04
Dash CAN
Lo B28 STC CAN to Dash @250 kbit/s F05
DESS
Immo B38 DESS Comms - not used
K-Line B24 K-Line - not used
1-3: See Calibration and Wiring Notes