MoTeC PWC Plug-In ECU - Manual (Page 82)

MoTeC Appendices
Sea-Doo Lambda Sensor (all model years)
Suitable sensor mounting position is at rear of exhaust manifold, next to water
fitting.
Lambda Aim Error Display (Sea-Doo 2007-2009 only)
Sea-Doo models from 2007-2009 transmit the VTS Trim level from the M
ECU to the dash (Custom Dataset 1, Item 3).
With the Lambda sensor installed, this dash display can be reconfigured
Lambda Aim Error display. This will provide very useful feedback whilst
tuning.
The display can be set up, so that if Lambda is on Aim, the bar graph will be
centred. An Aim error of 0.10 will move the bar to the top or bottom of the
gauge.
This function uses the IGN5 table which is included in the Base Map
To setup the display for Lambda aim error
1. On the Adjust menu, click General Setup.
2. Click Communications and then Setup Custom Data Sets
3. Select Item 3 – Trim Level (VTSLev) and then click
4. Select the Show Non-Sensor Channels check box.
5. Enter Ign Out5 Duty Cycle in the Search Text box and
6. Click OK to leave the Custom Data Sets screen.
7. Save the altered configuration file with a new name.
Note – this function is not possible with Sea-Doo 2010 models.
75
t rear of exhaust manifold, next to water
2009 only)
t the VTS Trim level from the M400
can be reconfigured as a
y useful feedback whilst
f Lambda is on Aim, the bar graph will be
An Aim error of 0.10 will move the bar to the top or bottom of the
Base Map.
Setup Custom Data Sets.
and then click Change.
box.
and click OK.
oo 2010 models.