J&M GC-24T Assembly - Manual (Page 2)

GC24
t
-1 G
rain
C
art
a
ssembly
-2-
For stability set the axle weldment up on blocks using an overhead hoist and chain. The blue sticker or
tack welds on the axle should face the front. For the scale option go to steps 3 & 4 for axle & Frame
installation instructions go to step 2.
STEP - 1
STEP - 2
Attach the main frame. Set the rear end onto the axle and the front end on another block. Use (8) M24 x
75MM and (8) M24 nylon locking hex nuts to fasten main frame to the axle.
M24 x75
mm
Bolt
M24 Lock Nut
through this assembly if the M10 x 25MM
serrated flange hex bolts are not long
enough in certain situations use the M10 x
35MM serrated flange hex bolts.
Tack Weld or Blue Sticker