J&M GC-24T Assembly - Manual (Page 38)

GC24
t
-1 G
rain
C
art
a
ssembly
-38-
STEP - 73
STEP - 72
Install the auger top tube assembly and pivot pin with 1/2” x 1-1/2” bolts, extra large washers
and lock nuts. Be sure to match numbers that are welded on the hinge plates of both the bottom
and top tub assemblies (if top tube has a 7 it goes with the bottom tube that has a 7).
Install the adjustable auger rest pad. First install the adjustable auger bolt on rest plate. Use (4) M10 x 25
MM serrated hex head bolts and (4) M10 serrated hex flange nuts. Next attach the adjustable auger rest.
Use (2) M10 x 40 MM, (2) M10 nylon washers, and (2) M10 serrated hex flange nuts. The washers go onto
the slotted side.
Adjust auger rest pad. Move
the rest pad up or down until
both circled points in the im-
age above are touching the
rest pad. Then drill through
the shell in the remaining
holes. Use (4) M10 x 40 hex
bolts and (4) M10 nylon
locking hex nuts.