American Panel HURRICHILL AP20BC175-2 - Manual (Page 18)

AP20BC175-2 Manual
17
y. To change to YES or NO, press or then
press .
NO Blinks
z. To change to YES or NO, press or then
press .
NO Blinks
aa. To change to YES or NO, press or then
press .
NO Blinks
The display will show for 2 seconds:
Then the controller will go into “OFF” state.
NOTE: During programming key can be used to return to the previous screen (except at
the steps 1h, 1i and 3d, when it has different functi
INITIAL PROGRAMMING
PRINT DURING CYCLE
NO
INITIAL PROGRAMMING
RECIPES?
NO
INITIAL PROGRAMMING
NAFEM COMMUNICATION
NO
INITIAL PROGRAMMING
COMPLETE
ons).
key is used to confirm the settings and advance to the next screen.
At any time, to bring the controller to “OFF” state, just pres the (“ON/OFF”) button.
2. PROGRAMMING THE CYCLES
a. With the display reading "OFF", press .
b. Enter the password (see page 14), then press
.
OFF
PARAM. PROGRAMMING
ENTER PASSWORD
***
AUTOMATIC SOFT CYCLE PARAMETERS PROGRAMMING
The LED for "A" will be "ON".
The LED'S for cycles will be blinking.
c. Press . The LED for "SOFT" will be steady
"ON".
PARAM. PROGRAMMING
AUTOMATIC MODE
CHOOSE
PROGRAMMING CYCLE