Analog Way Eikos - Manual (Page 37)

Output selection settings
To set up the output, go in the Main Output or Preview Output menu and choose first the adapted format/
resolution, and then the appropriate rate for your screens by using the knob button and the Enter button.
Main Output → Output Format → Output rate
Use the native resolution of your screens/projectors in order to obtain the best image quality. In the Preview
Output menu, you can also match the output configuration the Main Output to the Preview Output by check-
ing the case Sync w/Out 1. It allows you to set up your outputs via the output 1 menu.
Preview output → Synch w/Out 1
Some other settings are available too:
-
The Output sync. polarity.
- The Gamma: use this feature to set up the output Gamma.
- Flicker Filter (Video Out only): apply a flicker filter on your video output.
- Analog type: set up the type of synchronisation of your Analog output.
- DVI type: set up the type of color space of your Digital output.
- HDCP detection: set up to enable/disable the HDCP detection on the output.
- Background colour: add a background colour in place of the default black one.
- Test pattern: use test pattern on Main or Preview screen to configure your projectors.
*All changes have to be validated by pressing the ENTER button in order to be saved*
Input Sync. Loss Function
Source output selection
Once your inputs all have been configured, the output settings of the Eikos must be set according to the
machines plugged on your Eikos main and preview outputs (video projector, preview monitor...).
* NOTE *: If you want to use HDCP content from your sources, be sure to attach HDCP compliant screens
or projectors. If it’s not the case, the output image could be disabled.
Allows to display a frame or a source in case of sync loss of the selected input. To set up the Sync. Loss
function:
Menu → Control → Sync. Loss → Press Input# or Enabled
The selected input must be activated to be for being visible in case of sync loss.
35
* NOTE *: The output status can provide you all information about the output in real time. This
feature is particularly needed when HDCP is used with long cable to be sure that the communication
is well handled.
Video Out
The Video Out allows you the same settings as other outputs with some additional specific options:
-
Sharpness: set up the sharpness on the video out image.
- Flicker Filter: apply a flicker filter on your video output to eliminate flickering.
In Matrix mode, the menu “ Connection Mode” appears. It allows you to choose recording Output # 1
or Output # 2.