Analog Way Eikos - Manual (Page 49)

Logos input setup menu
In the Logos/Frames menu, the logos can be deleted in the Erase menu:
Logos/Frames menu → Erase menu → Select Logo#
Memorizing logos in the Eikos
1. In the Input Selection section, press the source button (#1 to #12) of the source you wish to record as a
logo. The source button will start blinking.
2. Select the Logos/Frames menu by scrolling through the menu with the scroll knob, then pressing the
ENTER button.
3. Select Record Logos in the Logos/Frames menu by rotating the scroll knob, then pressing ENTER. A small
white rectangle will appear on your main display, indicating the logo that will be captured.
4. Adjust logo size, position, and fine tune key attributes by rotating the scroll knob and pressing ENTER to
memorize logo settings.
5. Select an empty logo memory (empty logos are indicated in the sub-menu) to store the logo into. Press
the ENTER button. The Eikos will display a progress status bar on the VFD screen.
6. In the Layer Selection section, press the LOGO # 1 button, and select logo number (#1 to #8) you wish to
use. Your logo will appear on the preview screen above any existing layer on screen.
7. Press the TAKE button. Your logo will appear on the main display.
Capturing an animated Logo
To capture animated Logo, display the exact content you want to save on the main screen, you can use the
freeze button. Then follow this step:
Logos/Frames menu → Record Anim menu → Set up your Anim →Store menu → logo#
To set up your animation, you have several features available:
-
Position / Size Adjustment
- Keying type
- Luma / Chroma key
- Recording time
- Cut out color
Select the animated logo #8 and wait until the unit finishes saving. Your animation is now saved and you can
use it through the background logo button.
Only one Animated logo can be saved in the Eikos.
47