Burkert Type TAT002 - Manual (Page 15)

0911 - 13
english
4 ASSEMBLY, INSTALLATION AND COMMISSIONING
4.1 General information regarding the installation and operation
ATTENTION!
• Do not lay cables for inputs next to lines carrying voltage.
• Avoid heavy vibrations, aggressive gases, heavy soiling
and damp.
NOTE • Before connecting the device, check that the power supply
corresponds to the values shown on the rating plate.
• Observe the maximum loading of the relay contacts (see
Technical data).
• Ensure that you install all sensors with sufficient separation
from lines carrying voltage, in order to avoid incorrect
temperature measurements and to protect the device from
voltage interference over the sensor inputs.
Panel Mounting clamp
4.2 Assembly
The device is designed for panel mounting in a 71 x 29 mm cutout, and is
secured with a mounting clamp.
In order to guarantee the front protection of IP65, a rubber seal must be fitted
behind the mounting frame (optional for RG-C).
Thje ambient temperature form problem-free operation lies in the range from
0 ... +60°C.
Ensure sufficient ventilation through the cooling slots.