Burkert Type 8076 - Manual (Page 17)

17
Installation and wiring
Type 8026- 8036- 8076
7. insTAllATion AnD WirinG
7.1. safety instructions
danger
risk of injury due to high pressure in the installation.
• Stop the circulation of fluid, cut off the pressure and drain the
pipe before loosening the process connections.
risk of injury due to electrical voltage.
• Shut down and isolate the electrical power source before
carrying out work on the system.
• Observe all applicable accident protection and safety regula-
tions for electrical equipment.
risk of injury due to the nature of the fluid.
• Respect the prevailing regulations on accident prevention and
safety relating to the use of aggressive fluids.
Warning
risk of injury due to non-conforming installation.
• The electrical and fluid installation can only be carried out by
qualified and skilled staff with the appropriate tools.
• Install appropriate safety devices (correctly rated fuse and/or
circuit-breaker).
• Respect the assembly instructions for the fitting used.
risk of injury due to unintentional switch on of power supply
or uncontrolled restarting of the installation.
• Take appropriate measures to avoid unintentional activation of
the installation.
• Guarantee a set or controlled restarting of the process sub-
sequent to any intervention on the device.
note
the tightness of the device is not guaranteed when the cover
is removed.
• Once the cover is removed, prevent the projection of liquid
inside the housing.
the device may be damaged if a metal component comes
into contact with the electronics.
• Prevent contact of the electronics with a metal component
(screwdriver, for example).
English