Burkert Type 8056 - Manual (Page 41)

SE 56
41
Fixing screw
of board
‰ Unscrew the screw as indicated in pic. 1
‰ Lift the board, remove the flat cable
from the display (pic. 2) and
completely extract the board from
the box
Pic.2
4 mm hex spanner Display
‰ Partially unscrew the screw fixing the
display to allow the angular shift and
extraction of the display
Note: Do not unscrew entirely the screw
Take off the
flat cable
1
2
3
4
Display
‰ Rotate the display to the desired location,
verify the correct set of the seal, the cleaning
of the contact surfaces it set the display
housing.
‰
Place the fixing angles in the suitable
positions (pic. 5) and screw down firmly until
they make contact with the display housing.
‰ Screw up tightly the 4 screws (1, 2, 3, 4)
indicated in pic. 4
Pic.6
Pic.4
Pic.7
APPENDIX: DISPLAY ROTATION PROCEDURE
Note: the display is rotable ONLY in the aluminum IP67 version.
Pic.3
‰ Restore the flat cable connection to the display
‰
Verify the board is set correctly in the fixing
clip (pic. 7)
‰
Fix the board to the box to complete the
assembly process.
Pic.5
Pic.1