Fluid Components International FLT Series Rack Mount - Manual (Page 60)

Fluid Components Intl ERRATA 17EN000019 Rev. A
(Apply to Doc. No. 06EN003250 Rev. N/C) 1 FLT

Series FlexSwitch

Rack Mount
Approved CE marking FLT Series FlexSwitch Configurations
Approved Options
1) all process temperature ranges
2) all metallic sensor elements
3) all process connections and flanges
4) all insertion U-lengths
5) aluminum and 300 series stainless steel NEMA 4X local enclosures
6) all specified application combinations
7) all cable jackets and lengths
Approved Part Numbers
Conditionally Approved CE marking FLT Series FlexSwitch Configurations
24 VDC Operation
Since the manufacturer does not supply the power source for these connections, the responsibility for the
conditioning of these sources and associated compliance to the EMC Directive shall be the responsibility of the User.
Rack Mounted Control Circuit Options
The models included in this family are rack mounted (code 3 block 9 as derived from the above chart) control circuit
boards. Since the manufacturer does not supply an EMC enclosure for these configurations, the associated
compliance to the EMC Directive shall be the responsibility of the User.
Appendix E. CE Conformance
ERRATA DESCRIPTION
Appendix E is added for the CE mark. Also a wire length Table is added to the installation. See the following
information.
3
1 2 3 4 5 6 7
C D E
8
1 or 2
9 10 11 12
0 A B
C D F
13 14 15
FLT93-S
or
FLT93-F
All options conform to CE marking
Requirements.
General Sensing Element Control Circuit
X Y X or Y options only conform to CE
All other configurations must be approved for CE marking conformity by FCI's Engineering Department.