Fluid Components International CMF Series Manual Installation of Electronics - Manual (Page 12)

In
st
allation of signal con.
FlexCOR
™
Model CMF Series 42
Fluid Components Intl
Document 06EN003327 Rev. -
5.2.11 Compact (Integral)
Ex-d version
Location of the
SENSORPROM ®
memory unit
The SENSORPROM ® unit is normally factory-installed. To remove the
SENSORPROM ® unit, use the following procedure:
1. Remove the rear cover, by loosening the safety tap allen screw (M3), and turn the rear cover
counter-clockwise.
2. Remove the electronics using the holes provided.
The SENSORPROM ® unit is placed at
the bottom of the housing.
The SENSORPROM ® unit can be
installed/removed by screwing/
unscrewing the 6 terminal screws
connecting the SENSORPROM ® unit.
The label on the SENSORPROM ® unit
must face outwards.