Fluid Components International CMF Series Manual Installation of Electronics User Manual
Page 8
Advertising
In
st
allation of signal con.
FlexCOR
™
Model CMF Series
38
Fluid Components Intl
Document 06EN003327 Rev. -
5.2.7 Installation in panel
mounting enclosure
(front of panel)
1. Mount the SENSORPROM
®
unit on the connection board as shown.
The SENSORPROM
®
unit is supplied with the sensor.
2. Fit the enclosure in a cut out at the front of a panel. Fasten the four screws accessible at the
front.
3. Connect the cables as shown under "Electrical connection".
4. Plug in the transmitter and close the cover.
Advertising