Clear-Com Production-Maestro-Pro - Manual (Page 38)

4.15 Erasing changes to conferences
The Eraser [ ] is used to reset conferences to the EHX configuration default, erasing any
changes that were made in Production Maestro Pro.
To use the Eraser:
1. In Configure Palette, drag the Eraser [ ] from the Configure Palette toolbar (directly
above the canvas) onto the palette.
2. In Assignment, drag the Eraser to a conference to erase the assignments you made in
Production Maestro Pro.
Important note:
If you enable the Eraser leaves monitors, idents and alias names setting in Settings, any
idents [ ], monitors [ ] and alias labels [ ] that you added to the
conference are preserved when you use the Eraser. All other items are erased as usual.
If you enable the Prompt when erasing conference setting in Settings, a prompt is
displayed asking you to confirm the erasure operation.
For more information, see 4.19.3 Configuring prompts and other settings.
4.15.1 Erasing changes to preset conferences
If you apply the Eraser [ ] to a preset conference [ ], and then add that preset
conference to an existing conference [ ], the members are erased and then replaced
with the members of the preset conference.
Note:
Preset conferences are only created within Production Maestro Pro are not sent to the matrix. Only
when they are applied to existing conferences are changes sent to the matrix.
Tip: For more information about preset conferences, see 4.13 Preset conferences
38 Eclipse Production Maestro Pro User Guide