Clear-Com Production-Maestro-Pro - Manual (Page 46)

Eraser leaves monitors, idents
and alias names
When you use the Eraser Tool [ ] in Configure
Palette mode to reset conferences to the EHX
configuration default, any monitors, idents and aliases that
were added are preserved.
All other changes that you made in Production Maestro Pro
are erased.
For more information about the Eraser, see
4.15 Erasing changes to conferences.
Show and apply idents in
fourwires An ident [ ] is applied and displayed on four-wires /
panels used in conferences.
Enable conference member
filters When this setting is enabled, the member filter icon
[ ] is displayed in the right hand corner of conferences
in Configure Canvas mode.
To use the member filter, see
4.14 Filtering members in conferences.
Important note:
Filtering members is part of the conference configuration
process. You can only use member filtering in Configure
Canvas mode.
Enable level adjustment Enables you to adjust the audio levels on panels, four-
wires, monitors and idents (see 4.12 Controlling input and
output levels).
Only allow 1 source to be
added to a monitor’s fourwire
viewer To prevent issues arising from competing audio sources,
you can restrict the number of sources that can be added to
a monitor [ ] in a Port Viewer to a single audio
source.
Advanced setting Comments / Description
Enable idents / monitoring of
fourwires on the palette that are
not in use A way to expedite the preparation of four-wires for
conference configuration.
Enables you to assign idents [ ] and monitors
[ ] to four-wires on the palette, in both Configure
Palette and Assignment modes.
Table 10: Settings
46 Eclipse Production Maestro Pro User Guide