Clear-Com Production-Maestro-Pro - Manual (Page 49)

However, if an attempt is made to assign a meter that requires an additional meter and no free
meters are available, the following message is displayed:
There were not enough free meters to fulfil the request.
Because the audio level information is broadcast by the LMC-64 cards, the Production Maestro Pro
clients must be on the same network as the LMC-64 cards (unless switches or routers are configured
to forward the broadcast data between networks).
Note:
Production Maestro Pro does not require the IP address of the LMC-64 card.
Warning:
The use of meters consumes PC system resources. If extensive use is being made of audio level
metering, a minimum specification PC may not be suitable (see 1.2 System requirements ).
Meter functions Comments / Description
Input meter Input meters display the audio level into the matrix from a port,
after input level adjustment has been applied.
Output meter Output meters display the audio output level from the matrix to a
port after output level adjustment has been applied.
Conference meter Conference meters display the mixed audio level. Conference
members can hear their own audio output if their output level is
set to 0 dB.
Table 12: Meter functions
4.20.1 Adding a meter to a four-wire on the palette
To add a meter to a four-wire on the palette:
1. In Configure Palette, add the required four-wire [ ] to the palette.
2. To add an input meter, drag the meter [ ] from the Configure Palette toolbar to the
left-hand side of the four-wire:
The left-hand side of the four-wire turns green [ ].
The meter scale [ ] is displayed at the top of the four-wire.
49 Eclipse Production Maestro Pro User Guide