INTELLINET NETWORK NSC15-WG User Manual User Manual
Page 61
- 61 -
Camera -> General (Style 2):
RTSP:
Specify the RTSP port here. The default port is 554.
RTP:
Define the RTP port range here.
Image Rotated: Choose from one of the following options: “None,” “Mirror,”
“Flip” and “Mirror + Flip.” With this function you can mirror
the image vertically, horizontally or both. The default value is
“None.”
Audio Codec:
Here you can define which audio codec the camera uses.
There are four choices:
g.711 u-law / g.711 a-law: G.711, also known as Pulse Code
Modulation (PCM), is a very commonly used waveform codec
that generates a 64 kbps bit rate.
AMR Audio: AMR was adopted as the standard speech codec
by 3GPP in October 1998 and is now widely used in GSM and
UMTS. AMR Audio uses less bandwidth than g.711 audio.
When AMR is selected, you can specify the bit rate between
4.75 and 12.2 Kbps.
Off: Disable the audio function in the camera.
Audio mode:
There are two choices here. “Full Duplex” means that the
camera can send and receive audio simultaneously. “Half
Duplex” means the camera can send out audio to the
connected client PC, but can’t receive audio from it.