INTELLINET NETWORK NSC15-WG User Manual User Manual
Page 89
- 89 -
Protocol:
Select the correct protocol here. If you want the camera to
store the data on a shared Windows drive or folder, you
should select “SMB”. If you have a NAS device in your
network, the correct value depends on which protocol (SMB
or NFS) is supported by the NAS. In most cases both
protocols should be supported. If you are in a Unix/Linux
environment, your choice would be NFS.
Network storage location:
Enter the URL for the local storage here.
Workgroup:
Key in the workgroup that corresponds to your network.
Common values are WORKGROUP or MSHOME, but
ultimately it depends on the settings in your network.
User name:
Enter the user name for the shared network drive or folder
here. Make sure that the user account has read and write
permissions on the network drive or folder.
Password:
The password of the account goes here. As always, repeat
the password in the field below.
Click “OK” to save the settings. When done, click “Test” to verify the storage
settings. A popup window will open that informs you whether or not the test
was successful.