INTELLINET NETWORK NSC15-WG User Manual - Manual (Page 73)

- 73 -
Notify type:
Select which type of connection (DHCP, Static IP or PPPoE)
should be observed by the IP notification function. For
example, if you uncheck Static IP and your camera is set up
with a static IP address, you will not receive an e-mail
notification.
SMTP server name: Enter the domain name of the Sendmail server (outgoing e-
mail server) here.
SMTP server port: Port 25 is the standard port for SMTP connections. If your
SMTP server uses a different port, you can enter it here.
Authentication: Most SMTP servers require user authentication to prevent
abuse. Set this to On to enable authentication. Then select
the type of authentication. If you are not sure which value
is correct, contact your network administrator to find out.
When selecting POP before SMTP you need to specify the
POP server name (not shown on screen shot).
You also need to provide the SMTP user name and
password. Typically, these are the same values you use in
your e-mail program profile.
Recipient e-Mail address:
Enter the e-mail address to which the camera sends the e-
mail.
Administrator e-Mail address:
This is the sender e-mail address that the camera uses.
Subject: You can define the subject of the e-mail here.
Message: You can customize the message body of the e-mail here.
Click “Help” for more information on the parameters.