INTELLINET NETWORK NSC15-WG User Manual User Manual
Page 68
- 68 -
Camera -> Network -> PPPoE:
PPPoE is the most common form of connection for DSL-based Internet service.
You can use this function to connect the camera directly to a DSL modem. A
common application for this is where the network camera is installed in a
remote location where no network is present. In the location is a DSL Internet
connection (DSL modem), but no router or any other network infrastructure.
You can connect the camera to the DSL modem and enter your DSL account
information in the fields below.
IP address:
Displays the current IP address obtained from the Internet
Service Provider (ISP). It displays 0.0.0.0 if the camera is not
connected to the Internet via PPPoE.
User ID:
Enter the user ID for your DSL service here. The user ID has
been given to you by your ISP.
Password:
The password for the DSL account goes here. Re-type the
password in the field below.
DNS Server:
Typically, your ISP will send DNS Server information to the
camera when it connects. Some ISPs, however, require
entering specific DNS servers manually. In that case you can
activate the option “Use the following DNS server address”
and enter the primary and secondary DNS servers in the
fields below (not shown on the screen shot).