INTELLINET NETWORK 524711 Wireless 300N Outdoor PoE Access Point User Manual - Manual (Page 31)

25
Here are descriptions of every setup item:
Band
Select the wireless band you wish to use. By
selecting different band settings, you’ll be able
to allow or deny the wireless client of a certain
band.
If you select 2.4 GHz (B), 2.4 GHz (N) or 2.4
GHz (G), only wireless clients using the
wireless band you select (802.11b, 802.11
Draft-N or 802.11g) will be able to connect to
this access point.
If you select 2.4 GHz (B+G), then only wireless
clients using 802.11b and 802.11g bands will
be able to connect to this access point.
If you want to allow 802.11b, 802.11g and
802.11 Draft-N clients to connect to this
access point, select 2.4 GHz (B+G+N).
Main ESSID Input the ESSID (the name used to identify this
wireless access point) here. You can input up
to 32 alphanumerical characters. NOTE:
THE ESSID IS CASE SENSITIVE.
Site Survey When you use this access point as a wireless
station for an Ethernet network device to have
wireless capability, you have to associate it
with a working access point. Click “Select Site
Survey” and “Wireless Site Survey Table” will
pop up. It will list all available access points
nearby. You can select one access point in the
table and it will join the wireless LAN through
this access point. Go to Section 2-4-2-1 for
more information about the Wireless Site
Survey Table.
After you finish with the settings, click “Apply” and the following
message will be displayed: