INTELLINET NETWORK 524711 Wireless 300N Outdoor PoE Access Point User Manual - Manual (Page 36)

30
2-4-4 AP Bridge-Point to Multi-Point Mode
In this mode, this wireless access point will connect to up to four
wireless access points that use the same mode, and all wired
Ethernet clients of every wireless access point will be connected
together. You can use this mode to connect a network to other
networks that are physically isolated.
NOTE: When you set your access point to this mode, it will not
accept regular wireless clients anymore.
When you select AP Bridge-Point to Multi-Point, the following
options will be displayed:
Here are descriptions of every setup item:
Band
Select the wireless band you wish to use. By
selecting different band settings, you’ll be able
to allow or deny the wireless client of a certain
band.
If you select 2.4 GHz (B), 2.4 GHz (N) or 2.4
GHz (G), only wireless clients using the
wireless band you select (802.11b, 802.11
Draft-N or 802.11g) will be able to connect to
this access point.