INTELLINET NETWORK 524711 Wireless 300N Outdoor PoE Access Point User Manual - Manual (Page 39)

33
Draft-N or 802.11g) will be able to connect to
this access point.
If you select 2.4 GHz (B+G), then only wireless
clients using 802.11b and 802.11g bands will
be able to connect to this access point.
If you want to allow 802.11b, 802.11g and
802.11 Draft-N clients to connect to this
access point, select 2.4 GHz (B+G+N).
MAIN ESSID Input the ESSID (the name used to identify this
wireless access point) here. You can input up
to 32 alphanumerical characters. NOTE:
THE ESSID IS CASE SENSITIVE.
Multiple ESSID The access point supports multiple SSID
functions; up to four SSIDs can be set. If you
want to configure additional SSIDs, click this
button. For detailed descriptions of the
function, refer to Section 2-4-1-1.
Channel
Number
Select a channel number you wish to use. The
channel number must be the same as another
wireless access point you wish to connect to.
Associated
Clients Click “Show Active Clients” and a new popup
window will appear that contains information
about all wireless clients connected to this
access point. You can click “Refresh” in the
popup window to keep information up to date.
MAC address
1-4 Input the MAC address of the wireless access
point you wish to connect to.
Set Security Click this button to select an encryption mode
for this wireless link. A new popup window will
appear. Refer to Section 2-7 for detailed
descriptions.
After you finish with setting, click “Apply” and the following
message will be displayed: