CTI Products EXB Network Manager - Manual (Page 14)

Hot-Standby EXB / Network Manager Software Manual Hardware
CTI Products, Inc. Installation
10
68-11707-100
3.3 PC Network Interface Card Installation
Install the EXB Network Management Software first.
(See Section 4)
If you have completed the software driver installation, it is finally time to install
the Gesytec Easylon Network Interface card (CTI Part Number 90-11652.)
a. Turn off the PC and remove the power cord.
b. Open the PC case and locate an empty slot.
c. Remove the corresponding blank panel from the rear of the PC.
d. Insert the Network Interface card into the slot, ensuring that the
edge connectors are fully mated, and the slot in the rear panel-
mounting lug of the Network Interface card is aligned with the
threaded hole in the PC chassis.
e. Replace the screw to hold the card firmly in place.
f. Close the PC.
g. Reinsert the power cord and then restart the PC. A “New
Hardware Found” window will be displayed briefly when the
operating system recognizes the Network Interface card.
h. The S2-60617 MCN Adapter Screw Term to Dual RJ-45
has a pluggable screw terminal installed on it, but it fits only the
PCLTA module. The EXB Network Management Software
Network Interface uses a different terminal strip. Remove the
terminal strip from the adapter and attach the cable to the screw
terminal that ships with the Network Interface card.
i. Connect the MCN network cable(s) to the adapter. If only one
cable is specified, connect a 1250 terminator to the second RJ-45
jack.