Appendix b. mounting options, Rack mount option, B. m – CTI Products NCB/FL with Fiber Interface User Manual
Page 26: Ppendix, Ounting, Ptions, Figure 7 ncb module rack mounting
CTI Products, Inc.
NCB-EL/FL User Guide
Appendix B. Mounting Options
23
A
PPENDIX
B. M
OUNTING
O
PTIONS
Wall mount and EIA 19” rack mount kits are available as options for the NCB from CTI Products, Inc. The
wall mount kit includes brackets to allow a single NCB module to be mounted to any flat surface. The rack
mount kit includes an adapter allowing up to three NCB modules to be mounted in a single rack unit height.
Rack Mount Option
The rack mount option allows up to three NCB modules to be mounted in a one rack unit height (1.75 inches) of
a standard 19 inch rack. The modules are mounted in the rack plate by removing its’ front bezel and
remounting the module into the rack plate. Figure 7 shows an exploded view of the rack mount installation.
The top diagram shows the front view of the bracket with one module installed. The bottom two diagrams show
a side view of the module installation into the rack adapter and rack adapter installation into the rack,
respectively.
CA-80374-100
FACEPLATE
SPACER
1
2
3
4
5
9
8
7
6
ERR
ACT
PWR
RESET
WINK
ETH RX
ETH TX
CSVC RSVC
NETWORK
OUT
IN
ASYNC
NETWORK
NCB
NETWORK COMBINER
Figure 7 NCB Module Rack Mounting