Controlled Products Systems Group 26SASM - Manual (Page 26)

Secura Key • 22
8. Place reader and faceplate assembly against the mounting
plate. Faceplate will hook onto mounting plate by pushing
plate in and then sliding it down.
9. Secure faceplate to mounting plate using the two 4-40
screws.
10. Place faceplate door into door opening and rotate key 90°
clockwise.
FLUSH MOUNT WITHOUT 5S BOX (See Figure 10)
1. Use the wall cutout template provided. Locate template on
the wall. Transfer appropriate cutout corner locations to the
wall with a pointed instrument.
2. Draw lines from point to point, outlining cutout.
3. Cut out opening, being careful not to make opening larger
than indicated on the template.
4. Place mounting plate against wall in its proper location.
Using it as a template, mark four holes in corners. Remove
faceplate and using appropriate drill, drill four holes for
appropriate fasteners (8-32 fasteners are recommended).
5. Secure mounting plate to wall. Screws must be flat head
countersunk #6 or #8. For an outdoor installation, silicone
sealant is recommended between the mounting plate and
the wall.